Shout out to @primeweld for hooking us up at @midwestrailwaypreservation with a new MiG 285!
Need a tool, make a tool. The welds are less than pretty, but I needed to bang t
Need a tool, make a tool. The welds are less than pretty, but I needed to bang this post driver so I could set some heavy t-posts for the firewood pile. Didn’t want to buy one and this is all scrap material I had in the shop.
Found a legit reason to use the Dorian right angle attachment! Needed to drill a
Found a legit reason to use the Dorian right angle attachment! Needed to drill and tap 8 aluminum extrusions for a 3D printer add in for my son’s Voron Trident.
What’s the next best thing to visiting Keith Rucker’s shop in Georgia or Clarke
What’s the next best thing to visiting Keith Rucker’s shop in Georgia or Clarke Easterling’s foundry in Mississippi? Getting Keith and Clark to visit MY shop in Ohio!
What an honor it was to have @vintagemachinery and @clarkeeasterling67 stop by. They were passing through the Cleveland area and I was able to arrange a tour for them of the @midwestrailwaypreservation down at the old B&O roundhouse. While they were here, they accepted my invitation to see my small shop and how Keith has been an inspiration to me on my journey to being a machinist. I cannot thank them enough!
Removing a hardened bushing with a carbide end mill.
I can’t believe I am this close to 5k subscribers! Crazy to think how the channe
I can’t believe I am this close to 5k subscribers! Crazy to think how the channel has grown so much recently. Love it!
Finally able to put a 25% no exclusions coupon to work. Picked up this Yukon 9 d
Finally able to put a 25% no exclusions coupon to work. Picked up this Yukon 9 drawer cabinet. Using it mostly for storing tooling for the K&T horizontal mill, but there’s some other stuff in it as well. The red cabinet next to it used to hold these items and to say I overloaded it would be an understatement.
