Got this old Sears/Devilbiss air compressor restored. Replaced all the gaskets and piston rings. New controller and regulator valve. Fresh coat of paint. Super quiet compared to my other compressor. And this one can hold 7.4cfm@125psi.
.
.
.
Trying out some 7018 on the new welder.
Trying out some 7018 on the new welder. Haven’t run any SMAW for 2 1/2 years and that was only once or twice. This machine makes it seem too easy.
.
.
.
.
.
Checking one more thing off the EJS 2019 prep list.
Checking one more thing off the EJS 2019 prep list. Custom steering stabilizer mount. A friend made these tabs on his plasma. A little chewing gum and some JB Weld and voila!
.
.
.
Making lots of progress on the workshop.
Making lots of progress on the workshop. Concrete is set and cleaned and even managed to get the man doors and the overhead door installed. .
.
.
.
Almost there.
Almost there. A little more troweling and it will be time to sit back and watch it cure. Hopefully the heater will do what it needs to and keep the shop above freezing for the next couple of nights. .
.
.
.
Almost ready for concrete.
Getting a rocky start to the day.
Framing a small workshop in 30 seconds.
I think I could have lowered the wire feed speed just a little here
I think I could have lowered the wire feed speed just a little here, or maybe moved a little faster. Practice, practice, practice.
•
•
•
•
•
Put these Artec lower control arm skids on a friends Jeep.
Put these Artec lower control arm skids on a friends Jeep. It’s amazing how good my welds look in bad lighting and black paint. 😂
.
.
.
.
.
.
.
.